- Cold applied
- single component easy to apply
- can be applied on damp substrates
-
Cold applied
-
single component easy to apply
-
can be applied on damp substrates
-
joint free
-
Water based
POLYBIT® POLYCOAT RBE15 Can be used for a wide variety of applications, which includes the following: waterproofing & protective coating on shallow foundations. as damp proof membrane in sandwich construction. waterproofing in wet areas such as toilets, kitchens etc. curing compound on freshly cast concrete structures general vapor proof coating. Available sizes: 20L, 200L
The surface shall be cleaned thoroughly of all contaminants
like dust, traces of curing compound, oil, grease. Light
mechanical grinding/grit blasting/high pressure water jet
may be used to clean the surface of all the contaminants
depending on the degree of contamination on the surface
to be coated.
It is highly recommended to apply a priming coat prior
to the application of the Polycoat RBE 15 coating on the
substrate. The primer can be prepared in the site by diluting
Polycoat RBE 15 with 20% water. Depending on the dry film
thickness required, apply the rubberized bitumen coating . On vertical
areas, it is recommended to apply the coating in multiple
layers
Polycoat RBE 15 coating should be protected from getting
damaged due to the ongoing site activities and during
backfilling.
Coating can be protected either by a cement sand
screed (50mm thick) or by an asphaltic protection board
(Bituboard*).
Substrate must be sound, free from dust, loose particles, oil, traces of curing coampound and any contamination. May be applied to damp but not waterlogged surfaces.
There is no special primer. Primer can be prepared at site by diluting this product with 20% by volume of clean sweet water.
No. It is a water based green product