- Cold applied
- single component easy to apply
- can be applied on damp substrates
-
Cold applied
-
single component easy to apply
-
can be applied on damp substrates
-
joint free
-
Solvent free
POLYBIT® POLYCOAT RBE 1000Can be used for a wide variety of applications, which includes the following: waterproofing in wet areas such as toilets, kitchens etc. waterproofing & protective coating on concrete foundations & boundary wall footings. as damp proof membrane in sandwich construction. general vapor proof coating for both interior & exterior floors & walls. Avalaible sizes: 20L, 200L
The surface shall be cleaned thoroughly of all contaminants like dust, traces of curing compound, oil, grease. Light mechanical grinding/grit blasting/high pressure water jet may be used to clean the surface of all the contaminants depending on the degree of contamination on the surface to be coated.
t is highly recommended to apply a priming coat prior
to the application of the Polycoat RBE 1000 coating on
the substrate. The primer can be prepared in the site by
diluting Polycoat RBE 1000 with 20% water. Depending on the dry film
thickness required, apply the jellified emulsion. 2nd coat
shall be applied only after the previous coat dries off.
Polycoat RBE 1000 coating should be protected from
getting damaged due to the ongoing site activities.
coating can be protected either by a cement sand
screed (50mm thick) or by an asphaltic protection board
(Bituboard*).
Substrate must be sound, free from dust, loose particles, oil, traces of curing coampound and any contamination. May be applied to damp but not waterlogged surfaces.
There is no special primer. Primer can be prepared at site by diluting this product with 20% by volume of clean sweet water.
No. It is a water based green product