- Low viscosity allows penetration into the finest cracks
- Suitable for structural repairs
- Excellent bond to concrete, brick and masonry
-
Low viscosity allows penetration into the finest cracks
-
Suitable for structural repairs
-
Excellent bond to concrete, brick and masonry
-
Excellent bond also to moist substrates
-
Minimum creep under sustained load
-
Resistant to wide range of chemicals
POLYBIT® Polyinject EP is a 2-component injection resin on epoxide basis with specific chemical and physical properties to seal and bond cracks of widths between 0.05 mm and 10 mm. Due to its low mixture viscosity Polyinject EP can be applied pressure less as priming resin for concrete renovations or with injection pumps for injections. The particular material basis of Polyinject EP makes application even on slightly moist surfaces possible (see pull-off resistance).
The surface must be stable and free of separating
substances. Insufficiently firm layers and concrete slurry
must be removed. For this purpose the surface may be
prepared by suitable mechanical processes such as e.g.
shot blasting, milling or any other suitable mechanical
means
Pour the hardener (component B) into the resin (component
A) in the indicated mixing ratio and mix with an electrical
mixer (max. 300 rpm) until a homogenous mixture is
produced. Pour the hardener (component B) into the resin (component
A) in the indicated mixing ratio and mix with an electrical
mixer (max. 300 rpm) until a homogenous mixture is
produced.
In horizontal areas, wider cracks can be simply filled by
pouring in Polyinject EP. To avoid wastage and unnecessary
material consumption you may use mastics or tapes to
build a kind of reservoir along the cracks and treat the area
subsequently with a short-hair lambskin roller.
It is a PVA based tile adhesive for thin bed application of ceramic tiles
It is compatible with most of the partition boards such gupsum board, plywood, block board,
cement based board & polystyrene insulation board.
It is designed only for internal use.