- Excellent chloride &sulphate resistance
- High build coating no rpimer required
- abrasion resistant
-
Excellent chloride &sulphate resistance
-
High build coating no rpimer required
-
abrasion resistant
-
seam less fnish
-
easy to apply
POLYBIT® POLYPOXY CT To provide protection to concrete and metal structures such as:- concrete foundation steel pipes & ferrous metals off shore and marine structures. Available sizes: 20L
Surface to be coated with Polypoxy CT should be
structurally sound, dimensionally stable, clean and free
from laitance, oil or any other contaminants. Grit blasting
is recommended for complete removal of deleterious
materials and other contaminants which will affect the
adhesion from the substrate.
Mix part A and part B separately for a minute and then
transfer Part B (reactor) to Part A (base) and mix thoroughly
for 2 –3 minutes to get a uniform homogenous consistency.
Use a slow speed electric drill with a proprietary mixing
paddle
Polypoxy CT can be applied by brush, short hair roller
or airless spray. Apply the mixed material to a properly prepared substrate to achieve a uniform coating with
minimum wet film thickness of 200 microns. Subsequent
coats shall be applied after the coating achieves its initial
cure.
No primer required
No. It is a bitumen modified epoxy coating. As coal tar being carcinogenic, we are not using this in any of our products.
1L per coat can cover approximately 4 sqm at 200 microns dry film thickness