- Can be used on horizontal surfaces where light foot traffic is expected. (Balconies) – Interior and exterior waterproofing of basements. – Sealing of hairline cracks in concrete structures not subject to surface movement. – Can be used in waterproofing of drinking water tanks, reservoirs and clear wells. – Can be used for internal and external waterproofing and damp proofing concrete, mortar block work and brickwork.
- Good abrasion resistance
- Good abrasion resistance
-
Can be used on horizontal surfaces where light foot traffic is expected. (Balconies) – Interior and exterior waterproofing of basements. – Sealing of hairline cracks in concrete structures not subject to surface movement. – Can be used in waterproofing of drinking water tanks, reservoirs and clear wells. – Can be used for internal and external waterproofing and damp proofing concrete, mortar block work and brickwork.
-
Good abrasion resistance
-
Good abrasion resistance
-
Can be mixed to slurry or trowelable consistency
-
Non – toxic, therefore suitable for use in potable water applications
-
Improves the concrete/masonry appearance
POLYBIT® POLYFLEX T Can be used on horizontal surfaces where light foot traffic is expected. (Balconies) Interior and exterior waterproofing of basements. Sealing of hairline cracks in concrete structures not subject to surface movement. Can be used in waterproofing of drinking water tanks, reservoirs and clear wells. Can be used for internal and external waterproofing and damp proofing concrete, mortar block work and brickwork. Available pack size: 25KG.
All the substrates must be dry and free of dust, dirt, moss,
oil, grease and loose particles. All surfaces must be as true
and flat as possible. This can be achieved by wire brushing
or grit blasting. Unsound surfaces are to be removed and
repaired with a suitable repair mortar.
Polyflex T is supplied in two pre-measured parts which just
requires on site mixing. Do not mix more material than that
can be used within the pot life. Part mixing can be carried
out by mixing 4 volumes of powder with 1 volume of liquid
for Slurry consistency and 4.5 volumes of powder and 1
volume of liquid for a Trowelable consistency.
Polyflex T can be applied using trowel, notch trowel and
spray equipment. Work the material well into the prepared
substrate, filling all pores and voids. As with all cement based products, curing is important.
Protect newly applied product against direct sunlight, wind,
rain and frost. Allow a minimum 48 hours of air curing.
Yes. This can be applied on damp surface. But not on waterlogged area
No. Minimum 72 hours curing needed from the last coat.
Yes. It is a non-toxic product.