- Factory produced and packed to avoid on site variations
- Seals light weight aerated blocks.
- Seals pre-cast joints.
-
Factory produced and packed to avoid on site variations
-
Seals light weight aerated blocks.
-
Seals pre-cast joints.
-
Non-Toxic, compatible with drinking water.
-
Anti carbonation protection.
-
Non corrosive to metal
POLYBIT® Polyflex S for the total water proofing of water tanks both external and internal. Provides a good anti carbonation protective coating to exposed concrete structures, for coating on sea water structures, concrete reservoirs, lift walls and pits, water proof coating for roofs, domes, tunnels, swimming pools, lift wells, spillways, surge shafts, pre-cast slabs and other wet areas. Specially designed for permanent pondin. Available pack size: 12.5KG.
The surface must be clean and free from oil, grease, dust,
loosely adhering particles and any other contaminations.
The substrate to be coated with Polyflex Super must be
structurally sound. Cracks and pot holes are to be repaired
with Polycrete repair mortar prior to the application of the
system.
Polyflex Super is supplied in two parts and pre-measured.
Only on site mixing is needed. Slowly add the powder
to the liquid and mix using a slow speed drill fitted with
a suitable paddle. Apply the mixed material on to the damp surface by a soft
bristled brush, roller or a suitable spraying machine.
Allow the first coat to dry considerably, which typically will be 4-5 hours at 35°C. Application of the second coat is to be done at right angles to the first coat. However, pre wetting the first coat is not required prior to the application of the second coat. Curing should be done immediately after the coating has attained its final set
Yes. This can be applied on damp surface. But not on waterlogged area
No. Minimum 72 hours curing needed from the last coat.
Yes. It is a non-toxic product.