Skip to Content

POLYBIT Bitustick R 400

Polymer modified bituminous self adhesive anti-root, waterproofing and protection membrane

  • Excellent adhesion on different application decks
  • High resistance against root perforation
  • Excellent puncture and UV resistance

Features and benefits

SBS modified bituminous anti-root waterproofing and protection membrane. The modified bitumen is laminated onto a tough polypropylene fleece which has a high puncture, chemical and UV resistant properties.

Properties

Description

POLYBIT® BITUSTICK R 400 is used for waterproofing and protection of concrete foundations and any below ground structures. Due to its tough polypropylene fleece, it has high resistance to root perforations and can be used in areas where anti root properties are required.
Available pack size: 3.5mm

Documents and downloads

How to use

How to use

SURFACE PREPARATION & PRIMING

The surface shall be cleaned thoroughly of all contaminants
like dust, traces of curing compound, oil and grease. All
surface imperfections, protrusions, structurally unsound
and friable concrete must be removed and repaired with a
suitable Polycrete* concrete repair mortar.
Apply Polyprime SB* (solvent based primer) @ 4- 6 m²/L to
a clean smooth and dry surface by brush, roller or spray.
Allow the primer to dry prior to the application of the
membrane.

ALIGNMENT

Start the installation of all membrane plies from the low
point or drains, so the flow of water is over or parallel to
the plies, but never against the laps. All overlaps at the
membrane seams shall be installed so as to have “up”
slope laps over “down” slope laps. Begin membrane
application by unrolling the roll of Bitustick R 400
membrane and aligning the side laps. Re-roll the roll
halfway and stand on the unrolled portion to prevent
shifting. 

APPLICATION

Unroll only the required length and cut the piece to the desired shape. Place the membrane piece on the area to be covered and check whether they match with the profile of the marked substrate. Peel off the release film and carefully place the membrane with 50 mm overlap on the selvedges alone. The membrane shall be butt jointed at the ends using Bitutape TS as the underlayment to provide a watertight seal. 

Related articles

  • Bitustick Cool

    The Next Generation of Performed Bituminous Coatings 

  • Foundations and Flooring Systems

    Discover, feel and touch our systems, through our mockup simulation boxes 

  • Wet Areas and Flooring Systems

    Discover, feel and touch our systems, through our mockup simulation boxes 

  • Polycryl FR

    The Ultimate Fire Rated Coating Solution 

  • Polycryl PF

    Strong UV protection For Polyurethane Foam Roof  

  • Bituplus Ultra

    The Ultimate Torch On Membrane Range 

Related products

Related products

  • ${/content/heliux/adhesive/polybit/com/en/products/waterproofing-solutions/bitumen-thin-coatings/product#/polybit-polyprime-sb/SAP_0201WEP345J0/searchResult.productFields.MainImageAltText}
    POLYBIT POLYPRIME SB
    A quick drying solvent based low viscosity bitumen primer. It is used as a primer coat on masonry and concrete substrates to improve the adhesion of bitumen based membranes and coatings. 
  • ${/content/heliux/adhesive/polybit/com/en/products/waterproofing-solutions/bitumen-tapes-membranes-flashing/product#/polybit-bitutape-ts/SAP_0201WCP34GD7/searchResult.productFields.MainImageAltText}
    POLYBIT Bitutape TS
    Bitutape TS is a non-reinforced twin side adhesive bitumen membrane which comprises of polymerized bitumen sandwiched between a plastic release film on either side. 
Frequently asked questions

Frequently asked questions