- Excellent resistance to positive water & vapor pressure
- Good dimensional stability under tension
- Resistant to water borne chemicals
-
Excellent resistance to positive water & vapor pressure
-
Good dimensional stability under tension
-
Resistant to water borne chemicals
-
Excellent tensile, tear and puncture resistance
POLYBIT® EASYFELT P4160 is designed to be used for villas & small buildings on inverted roofs & terraces, balconies & patios.
Available pack size: 4mm
Apply Polyprime SB (Solvent based primer) @ 4-6 m²/L by brush, roller or spray. Allow the primer to dry prior to the application of the membrane.
Easyfelt P4160 membranes are installed by using a cylinder fed propane gas torch. Heat is applied to both the roll and the exposed laps of the membrane being overlapped onto. Caution: Do not over torch the membrane as this will expose the reinforcement and cause damage to it.
Easyfelt P4160 membranes are installed by using a cylinder fed propane gas torch. Heat is applied to both the roll and the exposed laps of the membrane being overlapped onto. Caution: Do not over torch the membrane as this will expose the reinforcement and cause damage to it.
An appropriate flashing membrane (Bituplus G) shall be lapped with the base membrane and taken up on the parapet wall and tucked into a groove cut into the concrete. The grooves will be sealed with a suitable mastic (Bitumastic).
It is recommended using solvent based bitumen primer conforming to ASTM D 41
Yes. It msut be protected from damages that may happen during the site activities.
No. It is not necessary to use bonding agents or twin sided tape for fixing on torch applied membranes. It can be applied by torching.