Skip to Content

POLYBIT BITUPLUS P 4180

APP modified bituminous waterproofing membrane

  • Excellent resistance to positive water & vapor pressure
  • Good heat resistance
  • Good dimensional stability under tension

Features and benefits

Plastomeric waterproofing membrane, manufactured from a rich mixture of bitumen and selected APP (Atactic Poly Propylene) polymers blended together to obtain excellent heat & UV resistance and waterproofing properties.

Properties

Description

POLYBIT® BITUPLUS P 4180 is used as a waterproofing membrane on inverted roofs & parapets terraces, balconies & patios, sunken slabs, bridges & tunnels,concrete foundations & footings,basements, inverted roofs & parapets, terraces, balconies & patios, sunken slabs, bridges & tunnels, concrete foundations & footings, basements.
Available pack size: 4mm

Documents and downloads

How to use

How to use

SURFACE PREPARATION

The surface shall be cleaned thoroughly of all contaminants like dust, traces of curing compound, oil and grease. All surface imperfections, protrusions, structurally unsound and friable concrete must be removed and repaired.

Priming & Alignment

Apply Polyprime SB* (solvent based primer) @ 4-6 m²/L to a clean smooth and dry surface by brush, roller or spray. Allow the primer to dry prior to the application of the membrane.
Start the installation of all membrane plies from the low point or drains, so the flow of water is over or parallel to the plies, but never against the lap. All overlaps at the membrane seams shall be installed so as to have
“up” slope laps over “down” slope lap. Begin membrane application by unrolling the roll of Bituplus P membrane and aligning the side laps. Side overlaps should be a minimum of 100 mm and the end overlap 150mm. 

Torching

Bituplus P 4180 membrane is installed by using a cylinder fed propane gas torch. Use of hand-held roofing torch is recommended as it affords a good control. Begin torching the embossed polyethylene side of the rolled portion of the membrane. As the membrane is heated the embossing starts to melt away exposing a shiny bitumen surface. Roll forward the membrane and press firmly with the boot or roller against the substrate to bond well. The propane flame should be moved from side to side and up the lap edge while the membrane is slowly unrolled and adhered to the surface. 

Related articles

  • Bitustick Cool

    The Next Generation of Performed Bituminous Coatings 

  • Foundations and Flooring Systems

    Discover, feel and touch our systems, through our mockup simulation boxes 

  • Wet Areas and Flooring Systems

    Discover, feel and touch our systems, through our mockup simulation boxes 

  • Polycryl FR

    The Ultimate Fire Rated Coating Solution 

  • Polycryl PF

    Strong UV protection For Polyurethane Foam Roof  

  • Bituplus Ultra

    The Ultimate Torch On Membrane Range 

Related products

Related products

  • ${/content/heliux/adhesive/polybit/com/en/products/waterproofing-solutions/bitumen-thin-coatings/product#/polybit-polyprime-sb/SAP_0201WEP345J0/searchResult.productFields.MainImageAltText}
    POLYBIT POLYPRIME SB
    A quick drying solvent based low viscosity bitumen primer. It is used as a primer coat on masonry and concrete substrates to improve the adhesion of bitumen based membranes and coatings. 
  • ${/content/heliux/adhesive/polybit/com/en/products/sealant-solutions/cs-bitumen/product#/polybit-bitumastic/SAP_0201PZP34GA7/searchResult.productFields.MainImageAltText}
    POLYBIT Bitumastic
    Bitumastic is a single component, solvent based bitumen rubber mastic joint sealant. 
Frequently asked questions

Frequently asked questions