- Suitable for ceramic, glazed, terracotta and porcelain tiles
- For indoor applications on walls & floors
- Recommended for periodically wet areas and utility rooms
-
Suitable for ceramic, glazed, terracotta and porcelain tiles
-
For indoor applications on walls & floors
-
Recommended for periodically wet areas and utility rooms
-
Easy workability
-
Suitable for walls and floors
CERESIT® CM 9 is a general-purpose cementitious tile adhesive that is used for indoor areas to permanently install tiles on: cement and cement-lime plasters, cement screeds and concrete substrates, light weight AAC and concrete blocks, wet areas (with periodic water penetration) e.g. bathrooms, kitchens and toilets, utility rooms. Available pack size: 20kg bag.
Ceresit CM 9 can be applied on even, load-bearing and compact substrates that are free of any substances that reduce adherence (e.g. grease, dirt and dust).
Indoors:
– Concrete (having residual moisture ≤2%)
– Cement screeds (without floor heating), plasters, cement and lime plasters (having residual moisture ≤1.5 %)
– Aerated concrete (that is dust-free and primed*)
Substrates must not be wet. Cement and concrete screeds must be fully cured prior to application. Any existing dirt, loose debris and coatings should be removed mechanically. Absorbent substrates should be primed* and left to dry for at least 2 hours. Surface unevenness of up to 5mm can be filled on the previous day using Ceresit CM 9 tile adhesive.
* Primed using a suitable primer from Henkel.
Application should be carried out in dry conditions at an air and surface temperature ranging between 5°C to 40°C. PRODUCT SAFETY: Contains cement. Strong alkaline reaction with moisture, so please protect your skin and eyes. In case of contact, wash immediately with plenty of water. Please seek medical attention in case of contact with eyes.
Pour Ceresit CM 9 into the precisely measured amount of clean cold water (as instructed in the technical data sheet) and mix using a slow speed drill until a homogenous mass without lumps is obtained. Leave for 2 minutes and then mix again. Apply the tile adhesive with a suitable notched trowel on the substrate. The size of the trowel’s teeth depends on the size of the tile. For indoor use, the tile adhesive should cover at least 65% of the tile’s backside. Place the tiles only during the open time of the adhesive. The width of the grouts should be the same and should depend on the size of the tile and exposure conditions. Excess tile adhesive can be removed with water, while hardened material can only be mechanically removed. Grouting on walls and floors can be done approximately after 8 hours and 24 hours respectively. Walkability is achieved after 24 hours. Expansion joints, corner joints and sanitary equipment surroundings shall be filled with a suitable sealant
This is a cementitious tile adhesive
Only for indoor applications on walls and floors
C1 as per EN 12004