- Very high load resistance
- Moisture- and weather-resistant
- High coverage
-
Very high load resistance
-
Moisture- and weather-resistant
-
High coverage
CERESIT® R710 Very low emission, 2-component polyurethane adhesive for bonding rubber tiles (e.g. Norament), design flooring (LVT), PVC and quartz vinyl tiles, outdoor coverings, concrete and earthenware, polystyrene, wooden materials and building boards on absorbent and nonabsorbent substrates.
Substrates must comply with the requirements of ATV
DIN 18 365 “Flooring work”, BS CP 8203 & 8204 or
compareable national standards. In particular, they must
be clean, free from structural defects, firm, dry and free of
substances which may impair adhesion.
The adhesive consists of two components (resin and
hardener) supplied in separate compartments of the bucket.
Use a sharp pointed tool to punch several holes through
the plastic plug and the bottom of the top container,
which acts as the bucket lid. Lift the top container slightly
to allow the hardener to drain completely into the bucket
below.
Carefully mix the resin and hardener using a
hand drill with stirring attachment for at least 2 minutes.
Apply the adhesive evenly to the subfloor using a suitable
notched trowel. Only apply as much adhesive as can be
laid with floor coverings within the working time. No open
time required. Install the floor coverings directly into the
adhesive bed.
This is an epoxy based bonding agent
This can be applied as a coating or by making bonding slurry
Yes it is green product with very low VOC content